3-1/4 x 9/16 Base

T-WM713

Images for: Length: 4, Grain: Smooth, and Straight or Radius?: Straight

Click here for a full scale, printable PDF

Price: $6.00 (per foot)

** Straight will bend like a belt around your waist.
** Minimum Radius is 6 inches.

Straight or Radius?
Grain
Length

Click Here for the Crown Radius Calculator

Crown Radius Calculator

Depth (inches):

Width (inches):

Enter Depth and Width and then press "Calculate" for help in auto-calculating Length and Radius. You may change the Length and Radius results as needed.

*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

Radius Calculator

Rise (inches):

Width (inches):

Enter Rise and Width and then press "Calculate" to auto-calculate Length and Radius.

*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

Please indicate whether your application has an Inside Radius or Outside Radius, as seen in Figure 1.

Will the crown be installed in the same orientation as the product image, or upside down?

Does the Wall or Roof Line Curve?
Note: If the wall radius changes (e.g. an Oval Room), then a template is required to provide a proper fit.
Please mail template to Resinart:
201 Old Airport Road
Fletcher, NC 28732

STRAIGHT BASE OR CASING BENDING AGAINST THICKNESS

Applications bending against the smaller dimension usually the 1/2" inch to 1-1/2" thick (i.e. Base with measurements 5/8" x 4-1/2") will bend easily in the direction of the lesser dimension with no pre-curving necessary.
Minimum radius 10".
Product has a tendency to cup when bent too tight on wall.
Moulding will not bend around 3/4" or 1-1/2" bullnose corners.