Square Capital for Chamfered and NON-Chamfered Columns

Half Circle Radius Calculator:

Radius (inches)
Enter Radius and press "Calculate" to auto-calculate Length.
Minimum Radius of at least 6" accepted.

*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

Quarter Circle Radius Calculator:

Radius (inches)
Enter Radius and press "Calculate" to auto-calculate Length.
Minimum Radius of at least 6" accepted.

*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

Crown Radius Calculator

Depth (inches):
Width (inches):
Enter Width and Depth and press "Calculate" to determine length.

*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

Full Circle Radius Calculator:

Radius (inches)
Enter Radius and press "Calculate" to auto-calculate Length.
Minimum Radius of at least 6" accepted.

* Note: Full Circles are manufactured in 2 pieces.
*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

Arch Radius Calculator:

Rise (inches):
Width (inches):
Enter Rise & Width and press "Calculate" to auto-calculate Length.
Minimum Radius of at least 6" accepted.

*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

a full scale template is required to manufacture ellipse radius curves

• Capture the inside of the curve on your template (paper).
• Measure around outside of template to determine length and add an additional 12 inches for cutting/mitering.
• Tightest radius in shoulder is 2x width of profile.
• Template length may be adjusted to ensure a proper fit.

Please mail template to:
Resinart East Inc.
201 Old Airport Road
Fletcher, NC 28732

a full scale template is required to manufacture oval radius curves

• Capture the inside of the curve on your template (paper).
• Measure around outside of template to determine length and add an additional 12 inches for cutting/mitering.
• Tightest radius in shoulder is 2x width of profile.
• Template length may be adjusted to ensure a proper fit.
• Ovals are made in 2 pieces (equal halves).

Please mail template to:
Resinart East Inc.
201 Old Airport Road
Fletcher, NC 28732

Radius Thin-Inside Calculator:

Radius (inches)
Enter Radius and press "Calculate" to auto-calculate Length.
Minimum Radius of at least 6" accepted.

*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

Radius Thick-Inside Calculator:

Radius (inches)
Enter Radius and press "Calculate" to auto-calculate Length.
Minimum Radius of at least 6" accepted.

*Length is automatically computed after pressing "Calculate", and rounded UP to the nearest foot AND allows extra material for trimming (4 foot minimum order).

a full scale template is required to manufacture custom radius curves

• Capture the inside of the curve on your template (paper).
• Measure around outside of template to determine length and add an additional 12 inches for cutting/mitering.
• Tightest radius in shoulder is 2x width of profile.
• Template length may be adjusted to ensure a proper fit.

Please mail template to:
Resinart East Inc.
201 Old Airport Road
Fletcher, NC 28732

** Capitals are designed to rest on TOP of column. They do NOT wrap around **